NetApp CN1610 - Page 317

314 Port Configuration Commands
The following command shows an example of the command output for all ports.
(CN1610) #show port all
Admin Physical Physical Link Link LACP
Actor
Intf Type Mode Mode Status Status Trap Mode
Timeout
--------- ------ --------- ---------- ---------- ------ ------- ---
--- --------
0/1 Enable Auto 100 Full Up Enable Enable
long
0/2 Enable Auto 100 Full Up Enable Enable
long
0/3 Enable Auto Down Enable Enable
long
0/4 Enable Auto 100 Full Up Enable Enable
long
0/5 Enable Auto 100 Full Up Enable Enable
long
0/6 Enable Auto 100 Full Up Enable Enable
long
0/7 Enable Auto 100 Full Up Enable Enable
long
0/8 Enable Auto 100 Full Up Enable Enable
long
1/1 Enable Down Disable N/A
N/A
1/2 Enable Down Disable N/A
N/A
1/3 Enable Down Disable N/A
N/A
1/4 Enable Down Disable N/A
N/A
1/5 Enable Down Disable N/A
N/A
1/6 Enable Down Disable N/A
N/A
The following command shows an example of the command output for a range of
ports.
(CN1610) #show port 0/1-1/6
Admin Physical Physical Link Link LACP
Actor
Intf Type Mode Mode Status Status Trap Mode
Timeout