NetApp CN1610 - System Information and Statistics Commands; Show Arp Switch; Show Eventlog

Chapter 4: Utility Commands 145
System Information and Statistics Commands
This section describes the commands you use to view information about system
features, components, and configurations.
show arp switch This command displays the contents of the IP stack’s Address Resolution
Protocol (ARP) table. The IP stack only learns ARP entries associated with the
management interfaces - network or service ports. ARP entries associated with
routing interfaces are not listed.
show eventlog
This command displays the event log, which contains error messages from the system. The event log is not cleared on a system reset.
Format
show arp switch
Mode Privileged EXEC
Term Definition
IP Address IP address of the management interface or another
device on the management network.
MAC Address Hardware MAC address of that device.
Interface For a service port the output is
Management. For a
network port, the output is the slot/port of the
physical interface.
Format
show eventlog
Mode Privileged EXEC
Term Definition
File The file in which the event originated.
Line The line number of the event.
Task Id The task ID of the event.