NetApp CN1610 - Show Port-Security

Chapter 5: Switching Commands 543
show port-security This command displays the port-security settings for the port(s). If you do not use
a parameter, the command displays the Port Security Administrative mode. Use
the optional parameters to display the settings on a specific interface or on all
interfaces. Instead of slot/port
, lag lag-intf-num can be used as an alternate
way to specify the LAG interface.
lag lag-intf-num can also be used to specify
the LAG interface where
lag-intf-num is the LAG port number.
For each interface, or for the interface you specify, the following information
appears:
The following shows example CLI display output for the command.
(CN1610) #show port-security 0/1
Format
no port-security mac-address sticky [<mac-address>
<vid>]
Mode ◆ Global Config
◆ Interface Config
Format
show port-security [{slot/port | all}]
Mode Privileged EXEC
Term Definition
Admin Mode Port Locking mode for the entire system. This field
displays if you do not supply any parameters.
Term Definition
Admin Mode Port Locking mode for the Interface.
Dynamic Limit Maximum dynamically allocated MAC Addresses.
Static Limit Maximum statically allocated MAC Addresses.
Violation Trap Mode Whether violation traps are enabled.
Sticky Mode The administrative mode of the port security Sticky
Mode feature on the interface.