NetApp CN1610 - Show Lldp Med Remote-Device

Chapter 5: Switching Commands 563
Required: 0.2 Watts
Source: local
Priority: low
show lldp med
remote-device
Use this command to display the summary information about remote devices that
transmit current LLDP MED data to the system. You can show information about
LLDP MED remote data received on all valid LLDP interfaces or on a specific
physical interface.
The following shows example CLI display output for the command.
(CN1610) #show lldp med remote-device all
LLDP MED Remote Device Summary
Local
Interface Remote ID Device Class
--------- --------- ------------
1/0/8 1Class I
1/0/9 2Not Defined
1/0/10 3Class II
1/0/11 4Class III
1/0/12 5 Network Con
Format
show lldp med remote-device {slot/port | all}
Mode Privileged EXEC
Term Definition
Local Interface The interface that received the LLDPDU from the
remote device.
Remote ID An internal identifier to the switch to mark each
remote device to the system.
Device Class Device classification of the remote device.