NetApp CN1610 - MAC Database Commands; Bridge Aging-Time; No Bridge Aging-Time; Show Forwardingdb Agetime

Chapter 5: Switching Commands 579
MAC Database Commands
This section describes the commands you use to configure and view information
about the MAC databases.
bridge aging-time This command configures the forwarding database address aging timeout in
seconds. The
seconds parameter must be within the range of 10 to 1,000,000
seconds. In an SVL system, the [fdbid/all] parameter is not used and will be
ignored if entered. In an SVL system, the [fdbid/all] parameter is not used and
will be ignored if entered.
no bridge aging-
time
This command sets the forwarding database address aging timeout to the default
value. In an SVL system, the [fdbid/all] parameter is not used and will be ignored
if entered.
show forwardingdb
agetime
This command displays the timeout for address aging.
Default 300
Format
bridge aging-time 10-1,000,000
Mode Global Config
Format
no bridge aging-time
Mode Global Config
Default all
Format
show forwardingdb agetime
Mode Privileged EXEC