NetApp CN1610 - Isdp Advertise-V2; No Isdp Advertise-V2; Isdp Enable; No Isdp Enable;Clear Isdp Counters

584 ISDP Commands
isdp advertise-v2 This command enables the sending of ISDP version 2 packets from the device.
no isdp advertise-
v2
This command disables the sending of ISDP version 2 packets from the device.
isdp enable This command enables ISDP on an interface or range of interfaces.
Note
ISDP must be enabled both globally and on the interface in order for the interface
to transmit ISDP packets. If ISDP is globally disabled on the switch, the interface
will not transmit ISDP packets, regardless of the ISDP status on the interface. To
enable ISDP globally, use the command “isdp run” on page 583.
no isdp enable This command disables ISDP on the interface.
clear isdp counters This command clears ISDP counters.
Default Enabled
Format
isdp advertise-v2
Mode Global Config
Format
no isdp advertise-v2
Mode Global Config
Default Enabled
Format
isdp enable
Mode Interface Config
Format
no isdp enable
Mode Interface Config
Format
clear isdp counters
Mode Privileged EXEC