NetApp CN1610 - No Sntp Server; Show Sntp; Show Sntp Client

228 Simple Network Time Protocol Commands
no sntp server This command deletes an server from the configured SNTP servers.
show sntp This command is used to display SNTP settings and status.
show sntp client This command is used to display SNTP client settings.
Format
no sntp server remove { ipaddress | ipv6address |
hostname }
Mode Global Config
Format
show sntp
Mode Privileged EXEC
Term Definition
Last Update Time Time of last clock update.
Last Attempt Time Time of last transmit query (in unicast mode).
Last Attempt Status Status of the last SNTP request (in unicast mode) or
unsolicited message (in broadcast mode).
Broadcast Count Current number of unsolicited broadcast messages
that have been received and processed by the SNTP
client since last reboot.
Format
show sntp client
Mode Privileged EXEC
Term Definition
Client Supported
Modes
Supported SNTP Modes (Broadcast or Unicast).
SNTP Version The highest SNTP version the client supports.