NetApp CN1610 - No Port-Channel System Priority; Show Lacp Actor; Show Lacp Partner

460 Port-Channel/LAG (802.3ad) Commands
no port-channel
system priority
Use this command to configure the default port-channel system priority value.
show lacp actor Use this command to display LACP actor attributes. Instead of slot/port
, lag
lag-intf-num
can be used as an alternate way to specify the LAG interface. lag
lag-intf-num
can also be used to specify the LAG interface where lag-intf-
num
is the LAG port number.
The following output parameters are displayed.
show lacp partner Use this command to display LACP partner attributes.
The following output parameters are displayed.
Format
no port-channel system priority
Mode Global Config
Format
show lacp actor {slot/port|all}
Mode Global Config
Parameter Description
System Priority The administrative value of the Key.
Actor Admin Key The administrative value of the Key.
Port Priority The priority value assigned to the Aggregation Port.
Admin State The administrative values of the actor state as
transmitted by the Actor in LACPDUs.
Format
show lacp actor {slot/port|all}
Mode Privileged EXEC
Parameter Description
System Priority The administrative value of priority associated with
the Partner’s System ID.