NetApp CN1610 - Show Isdp Entry

Chapter 5: Switching Commands 587
The following shows example CLI display output for the command.
(CN1610) #show isdp interface 0/1
Interface Mode
--------------- ----------
0/1 Enabled
The following shows example CLI display output for the command.
(Switching) #show isdp interface all
Interface Mode
--------------- ----------
0/1 Enabled
0/2 Enabled
0/3 Enabled
0/4 Enabled
0/5 Enabled
0/6 Enabled
0/7 Enabled
0/8 Enabled
show isdp entry This command displays ISDP entries. If the device id is specified, then only
entries for that device are shown.
Format
show isdp entry {all | deviceid }
Mode Privileged EXEC
Term Definition
Device ID The device ID associated with the neighbor which
advertised the information.
IP Addresses The IP address(es) associated with the neighbor.