Chapter 5: Switching Commands 583
ISDP Commands
This section describes the commands you use to configure the industry standard
Discovery Protocol (ISDP).
isdp run This command enables ISDP on the switch.
no isdp run This command disables ISDP on the switch.
isdp holdtime This command configures the hold time for ISDP packets that the switch
transmits. The hold time specifies how long a receiving device should store
information sent in the ISDP packet before discarding it. The range is given in
seconds.
isdp timer This command sets the period of time between sending new ISDP packets. The
range is given in seconds.
Default Enabled
Format
isdp run
Mode Global Config
Format
no isdp run
Mode Global Config
Default 180 seconds
Format
isdp holdtime
10-255
Mode Global Config
Default 60 seconds
Format
isdp timer
5-254
Mode Global Config
To Next Page
Loading...
