Chapter 5: Switching Commands 331
no spanning-tree
port mode
This command sets the Administrative Switch Port State for this port to disabled,
disabling the port for use by spanning tree.
spanning-tree port
mode all
This command sets the Administrative Switch Port State for all ports to enabled.
no spanning-tree
port mode all
This command sets the Administrative Switch Port State for all ports to disabled.
spanning-tree port-
priority
Use this command to change the priority value of the port to allow the operator to
select the relative importance of the port in the forwarding process. Set this value
to a lower number to prefer a port for forwarding of frames.
All LAN ports have 128 as priority value by default. PVSTP/PVRSTP puts the
LAN port with the lowest LAN port number in the forwarding state and blocks
other LAN ports.
The application uses the port priority value when the LAN port is configured as
an edge port.
Default enabled
Format
spanning-tree port mode
Mode Interface Config
Format
no spanning-tree port mode
Mode Interface Config
Default enabled
Format
spanning-tree port mode all
Mode Global Config
Format
no spanning-tree port mode all
Mode Global Config
To Next Page
Loading...
