NetApp CN1610 - No Random-Detect; Random-Detect Exponential Weighting-Constant; No Random-Detect Exponential-Weighting-Constant; Random-Detect Queue-Parms

610 Class of Service Commands
no random-detect Use this command to disable WRED, thereby restoring the default tail drop
operation for all queues on the interface.
random-detect
exponential
weighting-constant
This command is used to configure the WRED decay exponent for a CoS queue
interface.
no random-detect
exponential-
weighting-constant
Use this command to set the WRED decay exponent back to the default.
random-detect
queue-parms
This command is used to configure WRED parameters for each drop precedence
level supported by a queue. It is used only when per-COS queue configuration is
enabled (using the
cos-queue random-detect command).
Format
no random-detect
Modes ◆ Global Config
◆ Interface Config
Format
random-detect exponential-weighting-constant 0-15
Modes ◆ Global Config
◆ Interface Config
Format
no random-detect exponential-weighting-constant
Modes ◆ Global Config
◆ Interface Config
Format
random-detect queue-parms queue-id-1 [ queue-id-2 …
queue-id-n
] min-thresh thresh-prec-1 … thresh-prec-
n
max-thresh thresh-prec-1 … thresh-prec-n drop-
probability
prob-prec-1 … prob-prec-n
Modes ◆ Global Config
◆ Interface Config