NetApp CN1610 - Passwords Aging; No Passwords Aging; Passwords Lock-Out; No Passwords Lock-Out

74 User Account Commands
passwords aging Use this command to implement aging on passwords for local users. When a
user’s password expires, the user will be prompted to change it before logging in
again. The valid range is 1-365. The default is 0, or no aging.
no passwords aging Use this command to set the password aging to the default value.
passwords lock-out Use this command to strengthen the security of the switch by locking user
accounts that have failed login due to wrong passwords. When a lockout count is
configured, a user that is logged in must enter the correct password within that
count. Otherwise the user will be locked out from further switch access. Only a
user with Level 15 access can reactivate a locked user account. Password lockout
does not apply to logins from the serial console. The valid range is 1-5. The
default is 0, or no lockout count enforced.
no passwords lock-
out
Use this command to set the password lock-out count to the default value.
Default 0
Format
passwords aging 1-365
Mode Global Config
Format
no passwords aging
Mode Global Config
Default 0
Format
passwords lock-out 1-5
Mode Global Config
Format
no passwords lock-out
Mode Global Config