NetApp CN1610 - No Dos-Control Smacdmac; Dos-Control Tcpport; No Dos-Control Tcpport; Dos-Control Udpport

570 Denial of Service Commands
no dos-control
smacdmac
This command disables Source MAC address = Destination MAC address
(SMAC = DMAC) DoS protection.
dos-control tcpport This command enables TCP L4 source = destination port number (Source TCP
Port = Destination TCP Port) Denial of Service protection. If the mode is
enabled, Denial of Service prevention is active for this type of attack. If packets
ingress with Source TCP Port = Destination TCP Port, the packets will be
dropped if the mode is enabled.
no dos-control
tcpport
This command disables TCP L4 source = destination port number (Source TCP
Port = Destination TCP Port) Denial of Service protection.
dos-control udpport This command enables UDP L4 source = destination port number (Source UDP
Port = Destination UDP Port) DoS protection. If the mode is enabled, Denial of
Service prevention is active for this type of attack. If packets ingress with Source
UDP Port = Destination UDP Port, the packets will be dropped if the mode is
enabled.
Format
dos-control smacdmac
Mode Global Config
Format
no dos-control smacdmac
Mode Global Config
Default disabled
Format
dos-control tcpport
Mode Global Config
Format
no dos-control tcpport
Mode Global Config