NetApp CN1610 - Cos-Queue Strict; No Cos-Queue Strict; Random-Detect

Chapter 7: Quality of Service Commands 609
cos-queue strict This command activates the strict priority scheduler mode for each specified
queue for an interface queue on an interface, a range of interfaces, or all
interfaces.
no cos-queue strict This command restores the default weighted scheduler mode for each specified
queue.
random-detect This command is used to enable WRED for the interface as a whole, and is only
available when per-queue WRED activation control is not supported by the
device Specific WRED parameters are configured using the
random-detect
queue-parms
and the random-detect exponential-weighting-constant
commands.
When specified in Interface Config mode, this command affects a single interface
only, whereas in Global Config mode, it applies to all interfaces.
Modes
◆ Global Config
◆ Interface Config
Format
cos-queue strict queue-id-1 [queue-id-2 … queue-id-
n]
Modes ◆ Global Config
◆ Interface Config
Format
no cos-queue strict queue-id-1 [ queue-id-2 … queue-
id-n
]
Modes ◆ Global Config
◆ Interface Config
Format
random-detect
Modes ◆ Global Config
◆ Interface Config