NetApp CN1610 - Show Ipv6 Access-Lists

Chapter 7: Quality of Service Commands 685
show ipv6 access-
lists
This command displays an IPv6 access list and all of the rules that are defined for
the IPv6 ACL. Use the
[name] parameter to identify a specific IPv6 ACL to
display. The rate-limit attribute displays committed rate and committed burst
size.
Note
Only the access list fields that you configure are displayed. Thus, the command
output varies based on the match criteria configured within the rules of an ACL.
Format
show ipv6 access-lists [name]
Mode Privileged EXEC
Term Definition
Rule Number The ordered rule number identifier defined within
the IPv6 ACL.
Action The action associated with each rule. The possible
values are Permit or Deny.
Match All Indicates whether this access list applies to every
packet. Possible values are True or False.
Protocol The protocol to filter for this rule.
Committed Rate The committed rate defined by the rate-limit
attribute.
Committed Burst Size The committed burst size defined by the rate-limit
attribute.
Source IP Address The source IP address for this rule.
Source L4 Port
Keyword
The source port for this rule.
Destination IP
Address
The destination IP address for this rule.
Destination L4 Port
Keyword
The destination port for this rule.
IP DSCP The value specified for IP DSCP.