NetApp CN1610 - No Macfilter Adddest All; Macfilter Addsrc; No Macfilter Addsrc; Macfilter Addsrc All

Chapter 5: Switching Commands 473
no macfilter
adddest all
This command removes all ports from the destination filter set for the MAC filter
with the given
macaddr and VLAN of vlanid. The macaddr parameter must
be specified as a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
The
vlanid parameter must identify a valid VLAN.
macfilter addsrc This command adds the interface or range of interfaces to the source filter set for
the MAC filter with the MAC address of
macaddr and VLAN of vlanid. The
macaddr parameter must be specified as a 6-byte hexadecimal number in the
format of b1:b2:b3:b4:b5:b6. The
vlanid parameter must identify a valid
VLAN.
no macfilter addsrc This command removes a port from the source filter set for the MAC filter with
the MAC address of
macaddr and VLAN of vlanid. The macaddr parameter
must be specified as a 6-byte hexadecimal number in the format of
b1:b2:b3:b4:b5:b6. The
vlanid parameter must identify a valid VLAN.
macfilter addsrc all This command adds all interfaces to the source filter set for the MAC filter with
the MAC address of
macaddr and vlanid. You must specify the macaddr
parameter as a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
The
vlanid parameter must identify a valid VLAN.
Mode Global Config
Format
no macfilter adddest all macaddr
Mode Global Config
Format
macfilter addsrc macaddr vlanid
Mode Interface Config
Format
no macfilter addsrc macaddr vlanid
Mode Interface Config
Format
macfilter addsrc all macaddr vlanid