NetApp CN1610 - Show Dhcp L2 Relay Vlan; Clear Dhcp L2 Relay Statistics Interface

Chapter 5: Switching Commands 483
The following shows example CLI display output for the command.
(Broadcom FASTPATH Switching) #show dhcp l2relay agent-option vlan
5-10
DHCP L2 Relay is Enabled.
VLAN Id L2 Relay CircuitId RemoteId
--------- ---------- ----------- ------------
5 Enabled Enabled --NULL--
6 Enabled Enabled broadcom
7 Enabled Disabled --NULL--
8 Enabled Disabled --NULL--
9 Enabled Disabled --NULL--
10 Enabled Disabled --NULL--
show dhcp l2relay
vlan
This command displays DHCP vlan configuration.
clear dhcp l2relay
statistics interface
Use this command to reset the DHCP L2 relay counters to zero. Specify the port
with the counters to clear, or use the
all keyword to clear the counters on all
ports.
Format
show dhcp l2relay agent-option vlan vlan-range
Mode Privileged EXEC
Format
show dhcp l2relay vlan vlan-list
Mode Privileged EXEC
Parameter Description
vlan-list Enter VLAN IDs in the range 1–4093. Use a dash (–
) to specify a range or a comma (,) to separate
VLAN IDs in a list. Spaces and zeros are not
permitted.
Format
clear dhcp l2relay statistics interface {slot/port |
all
}