NetApp CN1610 - Dot1 X Unauthenticated-Vlan; No Dot1 X Unauthenticated-Vlan; Dot1 X User; No Dot1 X User

410 Port-Based Network Access Control Commands
dot1x
unauthenticated-
vlan
Use this command to configure the unauthenticated VLAN associated with the
specified interface or range of interfaces. The unauthenticated VLAN ID can be a
valid VLAN ID from 0-Maximum supported VLAN ID (4093 for FASTPATH).
The unauthenticated VLAN must be statically configured in the VLAN database
to be operational. By default, the unauthenticated VLAN is 0, i.e. invalid and not
operational.
no dot1x
unauthenticated-
vlan
This command resets the unauthenticated-vlan associated with the port to its
default value.
dot1x user This command adds the specified user to the list of users with access to the
specified port or all ports. The
user parameter must be a configured user.
no dot1x user This command removes the user from the list of users with access to the specified
port or all ports.
Mode Interface Config
Default 0
Format
dot1x unauthenticated-vlan vlan id
Mode Interface Config
Format
no dot1x unauthenticated-vlan
Mode Interface Config
Format
dot1x user user {slot/port | all}
Mode Global Config
Format
no dot1x user user {slot/port | all}
Mode Global Config