NetApp CN1610 - No Logging Email Urgent; Logging Email Message-Type To-Addr; No Logging Email Message-Type To-Addr; Logging Email From-Addr;No Logging Email from Addr

Chapter 4: Utility Commands 203
no logging email
urgent
This command resets the urgent severity level to the default value.
logging email
message-type to-
addr
This command configures the email address to which messages are sent. The
message types supported are
urgent, non-urgent , and both . For each supported
severity level, multiple email addresses can be configured. The
to-email-addr
variable is a standard email address, for example admin@yourcompany.com.
no logging email
message-type to-
addr
This command removes the configured to-addr field of email.
logging email from-
addr
This command configures the email address of the sender (the switch).
no logging email
from-addr
This command removes the configured email source address.
Format
no logging email urgent
Mode Global Config
Format
logging email message-type {urgent |non-urgent |both}
to-addr
to-email-addr
Mode Global Config
Format
no logging email message-type {urgent |non-urgent
|both} to-addr
to-email-addr
Mode Global Config
Default switch@broadcom.com
Format
logging email from-addr from-email-addr
Mode Global Config
Format
no logging email from-addr from-email-addr
Mode Global Config