NetApp CN1610 - No Macfilter Addsrc All; Show Mac-Address-Table Static

474 Static MAC Filtering Commands
no macfilter addsrc
all
This command removes all interfaces to the source filter set for the MAC filter
with the MAC address of
macaddr and VLAN of vlanid. You must specify the
macaddr parameter as a 6-byte hexadecimal number in the format of
b1:b2:b3:b4:b5:b6.
The
vlanid parameter must identify a valid VLAN.
show mac-address-
table static
This command displays the Static MAC Filtering information for all Static MAC
Filters. If you specify
all, all the Static MAC Filters in the system are displayed.
If you supply a value for
macaddr, you must also enter a value for vlanid, and
the system displays Static MAC Filter information only for that MAC address
and VLAN.
Note
Only multicast address filters will have destination port lists.
Mode Global Config
Format
no macfilter addsrc all macaddr vlanid
Mode Global Config
Format
show mac-address-table static { macaddr vlanid | all}
Mode Privileged EXEC
Term Definition
MAC Address The MAC Address of the static MAC filter entry.
VLAN ID The VLAN ID of the static MAC filter entry.
Source Port(s) The source port filter set's slot and port(s).