NetApp CN1610 - Logging Cli-Commands; No Logging Cli-Commands; Logging Console; No Logging Console;Logging Host

194 Logging Commands
logging cli-
command
This command enables the CLI command logging feature, which enables the
FASTPATH software to log all CLI commands issued on the system. The
commands are stored in a persistent log. Use the “show logging persistent” on
page 199
command to display the stored history of CLI commands.
no logging cli-
command
This command disables the CLI command Logging feature.
logging console This command enables logging to the console. You can specify the
severitylevel value as either an integer from 0 to 7 or symbolically through
one of the following keywords:
emergency (0), alert (1), critical (2),
error (3), warning (4), notice (5), info (6), or debug (7)
.
no logging console This command disables logging to the console.
logging host This command configures the logging host parameters. You can configure up to
eight hosts.
Default enabled
Format
logging cli-command
Mode Global Config
Format
no logging cli-command
Mode Global Config
Default disabled; critical when enabled
Format
logging console [severitylevel]
Mode Global Config
Format
no logging console
Mode Global Config