218 System Utility and Clear Commands
IPv4 ping failure:
In Case of Unreachable Destination:
(CN1610) # ping 192.168.254.222 count 3 interval 1 size 255
Pinging 192.168.254.222 with 255 bytes of data:
Received Response: Unreachable Destination
Received Response :Unreachable Destination
Received Response :Unreachable Destination
----192.168.254.222 PING statistics----
3 packets transmitted,3 packets received, 0% packet loss
round-trip (msec) min/avg/max = 0/0/0
In Case Of Request TimedOut:
(CN1610) # ping 1.1.1.1 count 1 interval 3
Pinging 1.1.1.1 with 0 bytes of data:
----1.1.1.1 PING statistics----
1 packets transmitted,0 packets received, 100% packet loss
round-trip (msec) min/avg/max = 0/0/0
IPv6 ping failure
(CN1610) #ping ipv6 2001::4
Pinging 2001::4 with 64 bytes of data:
Send count=3, Receive count=0 from 2001::4
Average round trip time = 0.00 ms
quit This command closes the current telnet connection or resets the current serial
connection. The system asks you whether to save configuration changes before
quitting.
reload This command resets the switch without powering it off. Reset means that all
network connections are terminated and the boot code executes. The switch uses
the stored configuration to initialize the switch. You are prompted to confirm that
the reset should proceed. The LEDs on the switch indicate a successful reset.
Format
quit
Modes â—† Privileged EXEC
â—† User EXEC
Format
reload
To Next Page
Loading...
Need help?
General
