284 Remote Monitoring Commands
Remote Monitoring Commands
Remote Monitoring (RMON) is a method of collecting a variety of data about
network traffic. RMON supports 64-bit counters (RFC 3273) and High Capacity
Alarm Table (RFC 3434).
There is no configuration command for ether stats and high capacity ether stats.
The data source for ether stats and high capacity ether stats are configured during
initialization.
rmon alarm This command sets the RMON alarm entry in the RMON alarm MIB group.
Format
rmon alarm alarm number variable sample interval
{absolute|delta} rising-threshold value [rising-event-
index] falling-threshold value [falling-event-index]
[startup {rising|falling|rising-falling}] [owner
string]
Mode Global Config
Parameter Description
Alarm Index An index that uniquely identifies an entry in the
alarm table. Each entry defines a diagnostic sample
at a particular interval for an object on the device.
The range is 1 to 65535.
Alarm Variable The object identifier of the particular variable to be
sampled. Only variables that resolve to an ASN.1
primitive type of integer.
Alarm Interval The interval in seconds over which the data is
sampled and compared with the rising and falling
thresholds. The range is 1 to 2147483647. The
default is 1.
To Next Page
Loading...
