Chapter 4: Utility Commands 255
Src_IP: 11.1.1.1 Dest_IP: 225.0.0.5 Type: Membership_Query Group:
225.0.0.5
The following parameters are displayed in the trace message:
no debug
igmpsnooping
receive
This command disables tracing of received IGMP Snooping packets.
Parameter Definition
RX A packet received by the device.
Intf The interface that the packet went out on. Format
used is unit/slot/port (internal interface number).
Unit is always shown as 1 for interfaces.
Src_Mac Source MAC address of the packet.
Dest_Mac Destination multicast MAC address of the packet.
Src_IP The source IP address in the ip header in the packet.
Dest_IP The destination multicast ip address in the packet.
Type The type of IGMP packet. Type can be one of the
following:
◆ Membership_Query – IGMP Membership
Query
◆ V1_Membership_Report – IGMP Version 1
Membership Report
◆ V2_Membership_Report – IGMP Version 2
Membership Report
◆ V3_Membership_Report – IGMP Version 3
Membership Report
◆ V2_Leave_Group – IGMP Version 2 Leave
Group
Group Multicast group address in the IGMP header.
Format
no debug igmpsnooping receive
Mode Privileged EXEC
To Next Page
Loading...
