Chapter 5: Switching Commands 407
no dot1x re-
authentication
This command disables reauthentication of the supplicant for the specified port.
dot1x system-auth-
control
Use this command to enable the dot1x authentication support on the switch.
While disabled, the dot1x configuration is retained and can be changed, but is not
activated.
no dot1x system-
auth-control
This command is used to disable the dot1x authentication support on the switch.
dot1x system-auth-
control monitor
Use this command to enable the 802.1X monitor mode on the switch. The
purpose of Monitor mode is to help troubleshoot port-based authentication
configuration issues without disrupting network access for hosts connected to the
switch. In Monitor mode, a host is granted network access to an 802.1X-enabled
port even if it fails the authentication process. The results of the process are
logged for diagnostic purposes.
Format
dot1x re-authentication
Mode Interface Config
Format
no dot1x re-authentication
Mode Interface Config
Default disabled
Format
dot1x system-auth-control
Mode Global Config
Format
no dot1x system-auth-control
Mode Global Config
Default disabled
Format
dot1x system-auth-control monitor
To Next Page
Loading...
