NetApp CN1610 - No Port Lacptimeout; Port Lacptimeout (Global Config); Port-Channel Adminmode

456 Port-Channel/LAG (802.3ad) Commands
no port lacptimeout This command sets the timeout back to its default value on a physical interface of
a particular device type (actor or partner).
Note
Both the no portlacptimeout and the no lacp actor admin state commands
set the values back to default, regardless of the command used to configure the
ports. Consequently, both commands will display in
show running-config .
port lacptimeout
(Global Config)
This command sets the timeout for all interfaces of a particular device type (actor
or partner) to either long or short timeout.
no port lacptimeout This command sets the timeout for all physical interfaces of a particular device
type (actor or partner) back to their default values.
Note
Both the no portlacptimeout and the no lacp actor admin state commands
set the values back to default, regardless of the command used to configure the
ports. Consequently, both commands will display in
show running-config .
port-channel
adminmode
This command enables all configured port-channels with the same administrative
mode setting.
Format
no port lacptimeout {actor | partner}
Mode Interface Config
Default long
Format
port lacptimeout {actor | partner} {long | short}
Mode Global Config
Format
no port lacptimeout {actor | partner}
Mode Global Config
Format
port-channel adminmode all