NetApp CN1610 - Show Vlan Remote-Span

Chapter 5: Switching Commands 469
show vlan remote-
span
This command displays the configured RSPAN VLAN.
The following shows example output for the command.
(CN1610)# show vlan remote-span
Remote SPAN VLAN
------------------------------------------------------------------
------
Source Port The port, which is configured as mirrored port
(source port) for the session identified with
session-id. If no source port is configured for the
session then this field is blank.
Type Direction in which source port configured for port
mirroring.Types are tx for transmitted packets and rx
for receiving packets.
Src VLAN All member ports of this VLAN are mirrored. If the
source VLAN is not configured, this field is blank.
Ref. Port This port carries all the mirrored traffic at the source
switch.
Src Remote VLAN The source VLAN is configured at the destination
switch. If the remote VLAN is not configured, this
field is blank.
Dst Remote VLAN The destination VLAN is configured at the source
switch. If the remote VLAN is not configured, this
field is blank.
IP ACL The IP access-list id or name attached to the port
mirroring session.
MAC ACL The MAC access-list name attached to the port
mirroring session.
Term Definition
Format
show vlan remote-span
Mode Privileged EXEC Mode