NetApp CN1610 - Passwords Strength-Check; No Passwords Strength-Check; Passwords Strength Maximum Consecutive-Characters; Passwords Strength Maximum Repeated-Characters

Chapter 3: Management Commands 75
passwords
strength-check
Use this command to enable the password strength feature. It is used to verify the
strength of a password during configuration.
no passwords
strength-check
Use this command to set the password strength checking to the default value.
passwords strength
maximum
consecutive-
characters
Use this command to set the maximum number of consecutive characters to be
used in password strength. The valid range is 0-15. The default is 0. Minimum of
0 means no restriction on that set of characters.
passwords strength
maximum repeated-
characters
Use this command to set the maximum number of repeated characters to be used
in password strength. The valid range is 0-15. The default is 0. Minimum of 0
means no restriction on that set of characters.
Default Disable
Format
passwords strength-check
Mode Global Config
Format
no passwords strength-check
Mode Global Config
Default 0
Format
passwords strength maximum consecutive-characters 0-15
Mode Global Config
Default 0
Format
passwords strength maximum consecutive-characters 0-15
Mode Global Config