438 Storm-Control Commands
no storm-control
unicast
This command disables unicast storm recovery mode for all interfaces (Global
Config mode) or one or more interfaces (Interface Config mode).
storm-control
unicast level
This command configures the unicast storm recovery threshold for all interfaces
(Global Config mode) or one or more interfaces (Interface Config mode) as a
percentage of link speed, and enables unicast storm recovery. If the mode is
enabled, unicast storm recovery is active, and if the rate of unknown L2 unicast
(destination lookup failure) traffic ingressing on an interface increases beyond
the configured threshold, the traffic will be dropped. Therefore, the rate of
unknown unicast traffic will be limited to the configured threshold.This
command also enables unicast storm recovery mode for an interface.
no storm-control
unicast level
This command sets the unicast storm recovery threshold to the default value for
all interfaces (Global Config mode) or one or more interfaces (Interface Config
mode) and disables unicast storm recovery.
storm-control
unicast rate
Use this command to configure the unicast storm recovery threshold for all
interfaces (Global Config mode) or one or more interfaces (Interface Config
mode) in packets per second. If the mode is enabled, unicast storm recovery is
Format
no storm-control unicast
Mode ◆ Global Config
◆ Interface Config
Default 5
Format
storm-control unicast level
0-100
Mode ◆ Global Config
◆ Interface Config
Format
no storm-control unicast level
Mode ◆ Global Config
◆ Interface Config
To Next Page
Loading...
