NetApp CN1610 - Box Services Commands; Environment Trap; Show Environment

Chapter 4: Utility Commands 187
Box Services Commands
This section describes the Box Services commands. Box services are services
that provide support for features such as temperature, power supply status, fan
control, and others. Each of these services is platform dependent. (For example,
some platforms may have temperature sensors, but no fan controller. Or, others
may have both while others have neither.)
Note
The bootloader version can only be supported on PowerPC platforms that use the
u-boot loader.
environment trap Use this command to configure environment status traps.
show environment Use this command to view information about the switch environment.
Format
environment trap {fan|powersupply|temperature}
Mode Global Config
Parameter Definition
fan Enables or disables the sending of traps for fan
status events. The default is enable.
powersupply Enables or disables the sending of traps for power
supply status events. The default is enable.
temperature Enables or disables the sending of traps for
temperature status events. The default is enable.
Format
show environment
Mode Privileged Exec