NetApp CN1610 - No Radius Server Retransmit; Radius Server Timeout; No Radius Server Timeout; Show Radius Servers

Chapter 3: Management Commands 113
no radius server
retransmit
The no version of this command sets the value of this global parameter to the
default value.
radius server
timeout
This command configures the global parameter for the RADIUS client that
specifies the timeout value (in seconds) after which a request must be
retransmitted to the RADIUS server if no response is received. The timeout value
is an integer in the range of 1 to 30.
no radius server
timeout
The no version of this command sets the timeout global parameter to the default
value.
show radius servers Use this command to display the authentication parameters.
Format
no radius server retransmit
Mode Global Config
Default 5
Format
radius server timeout seconds
Mode Global Config
Field Description
retries Maximum number of transmission attempts in the
range 1–30.
Format
no radius server timeout
Mode Global Config
Default Not applicable
Format
show radius servers { serverIP | name serverName }
Mode User EXEC