NetApp CN1610 - Boot Host Autosave; No Boot Host Autosave; Boot Host Autoreboot; No Boot Host Autoreboot

138 AutoInstall Commands
boot host autosave Use this command to automatically save the downloaded configuration file to the
startup-config file on the switch. When autosave is disabled, you must explicitly
save the downloaded configuration to non-volatile memory by using the
write
memory
or copy system:running-config nvram:startup-config command. If
the switch reboots and the downloaded configuration has not been saved, the
AutoInstall process begins, if the feature is enabled.
no boot host
autosave
Use this command to disable automatically saving the downloaded configuration
on the switch.
boot host
autoreboot
Use this command to allow the switch to automatically reboot after successfully
downloading an image. When auto reboot is enabled, no administrative action is
required to activate the image and reload the switch.
no boot host
autoreboot
Use this command to prevent the switch from automatically rebooting after the
image is downloaded by using the AutoInstall feature.
Default disabled
Format
boot host autosave
Mode Privileged EXEC
Format
no boot host autosave
Mode Privileged EXEC
Default enabled
Format
boot host autoreboot
Mode Privileged EXEC
Format
no boot host autoreboot
Mode Privileged EXEC