NetApp CN1610 - No Snmp-Server Group; Snmp-Server Host

Chapter 3: Management Commands 97
no snmp-server
group
This command removes the specified group.
snmp-server host This command configures traps to be sent to the specified host.
auth This group can be accessed only when using
Authentication but not Encryption. Applicable only
if SNMPv3 is selected.
priv This group can be accessed only when using both
Authentication and Encryption. Applicable only if
SNMPv3 is selected.
context-name The SNMPv3 context used during access.
Applicable only if SNMPv3 is selected.
read-view The view this group will use during GET requests.
The range is 1 to 30 characters.
write-view The view this group will use during SET requests.
The range is 1 to 30 characters.
notify-view The view this group will use when sending out traps.
The range is 1 to 30 characters.
Parameter Description
Format
no snmp-server group group-name {v1|v2c| 3
{noauth|auth|priv}} [context context-name]
Mode Global Config
Default No default hosts are configured.
Format
snmp-server host host-addr {informs [timeout seconds]
[retries retries]|traps version {1 | 2c }} community-
string [udp-port port] [filter filter-name]
Mode Global Config