Chapter 7: Quality of Service Commands 627
match secondary-
vlan
This command adds to the specified class definition a match condition based on
the value of the layer 2 secondary VLAN Identifier field (the inner 802.1Q tag of
a double VLAN tagged packet). The secondary VLAN ID is an integer from 0 to
4093. Use the [not] option to negate the match condition.
Mode Class-Map Config
Ipv6-Class-Map Config
Default none
Format
match [not] secondary-vlan
0-4093
Mode Class-Map Config
Ipv6-Class-Map Config
To Next Page
Loading...
