278 sFlow Commands
sflow sampler A data source configured to collect flow samples is called a poller. Use this
command to configure a new sFlow sampler instance on an interface or range of
interfaces for this data source if
rcvr_idx is valid.
Receiver Owner The owner name corresponds to the receiver name.
The identity string for the receiver, the entity making
use of this sFlowRcvrTable entry. The range is 127
characters. The default is a null string. The empty
string indicates that the entry is currently unclaimed
and the receiver configuration is reset to the default
values. An entity wishing to claim an
sFlowRcvrTable entry must ensure that the entry is
unclaimed before trying to claim it. The entry is
claimed by setting the owner string to a non-null
value. The entry must be claimed before assigning a
receiver to a sampler or poller.
Field Description
Format
sflow sampler {rcvr-indx | rate sampling-rate |
maxheadersize size}
Mode Interface Config
Field Description
Receiver Index The sFlow Receiver for this sFlow sampler to which
flow samples are to be sent. A value of zero (0)
means that no receiver is configured, no packets will
be sampled. Only active receivers can be set. If a
receiver expires, then all samplers associated with
the receiver will also expire. Possible values are 1-8.
The default is 0.
To Next Page
Loading...
