NetApp CN1610 - No Enable Password (Privileged EXEC); Passwords Min-Length; No Passwords Min-Length; Passwords History;No Passwords History

Chapter 3: Management Commands 73
no enable password
(Privileged EXEC)
Use the no enable password command to remove the password requirement.
passwords min-
length
Use this command to enforce a minimum password length for local users. The
value also applies to the enable password. The valid range is 8-64.
no passwords min-
length
Use this command to set the minimum password length to the default value.
passwords history Use this command to set the number of previous passwords that shall be stored
for each user account. When a local user changes his or her password, the user
will not be able to reuse any password stored in password history. This ensures
that users don’t reuse their passwords often. The valid range is 0-10.
no passwords
history
Use this command to set the password history to the default value.
Format
no enable password
Mode Privileged EXEC
Default 8
Format
passwords min-length 8-64
Mode Global Config
Format
no passwords min-length
Mode Global Config
Default 0
Format
passwords history 0-10
Mode Global Config
Format
no passwords history
Mode Global Config