634 DiffServ Policy Commands
police-two-rate This command is the two-rate form of the police command and is used to
establish the traffic policing style for the specified class. For each outcome, the
only possible actions are drop, set-cos-as-sec-cos, set-cos-transmit, set-sec-cos-
transmit, set-dscp-transmit, set-prec-transmit, or transmit. In this two-rate form
of the police command, the conform action defaults to send, the exceed action
defaults to drop, and the violate action defaults to drop. These actions can be set
with this command once the style has been configured.
policy-map This command establishes a new DiffServ policy. The
policyname parameter is
a case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying
the policy. The type of policy is specific to the inbound traffic direction as
indicated by the
in
parameter, or the outbound traffic direction as indicated by
the
out
parameter, respectively.
Format
police-single-rate {
1-4294967295 1-128 1-128
conform-action {drop | set-cos-as-sec-cos | set-cos-
transmit
0-7
| set-sec-cos-transmit
0-7
| set-prec-
transmit
0-7
| set-dscp-transmit
0-63
| transmit}
exceed-action {drop | set-cos-as-sec-cos | set-cos-
transmit
0-7
| set-sec-cos-transmit
0-7
| set-prec-
transmit
0-7
| set-dscp-transmit
0-63
| transmit}
[violate-action {drop | set-cos-as-sec-cos-transmit |
set-cos-transmit
0-7
| set-sec-cos-transmit
0-7
| set-
prec-transmit
0-7
| set-dscp-transmit
0-63
|
transmit}]}
Mode Policy-Class-Map Config
Format
police-two-rate {
1-4294967295
1-4294967295
1-128
1-
128
conform-action {drop | set-cos-as-sec-cos | set-
cos-transmit
0-7
| set-sec-cos-transmit
0-7
| set-
prec-transmit
0-7
| set-dscp-transmit
0-63
| transmit}
exceed-action {drop | set-cos-as-sec-cos | set-cos-
transmit
0-7
| set-sec-cos-transmit
0-7
| set-prec-
transmit
0-7
| set-dscp-transmit
0-63
| transmit}
[violate-action {drop | set-cos-as-sec-cos | set-cos-
transmit
0-7
| set-sec-cos-transmit
0-7
| set-prec-
transmit
0-7
| set-dscp-transmit
0-63
| transmit}]}
Mode Policy-Class-Map Config
To Next Page
Loading...
