512 IGMP Snooping Configuration Commands
sending a query on an interface because it did not receive a report for a particular
group in that interface. This value must be less than the IGMP Query Interval
time value. The range is 1 to 25 seconds.
no set igmp
maxresponse
This command sets the max response time (on the interface or VLAN) to the
default value.
set igmp
mcrtrexpiretime
This command sets the Multicast Router Present Expiration time. The time is set
for the system, on a particular interface or VLAN, or on a range of interfaces.
This is the amount of time in seconds that a switch waits for a query to be
received on an interface before the interface is removed from the list of interfaces
with multicast routers attached. The range is 0 to 3600 seconds. A value of 0
indicates an infinite time-out, i.e. no expiration.
Default 10 seconds
Format
set igmp maxresponse [
vlan_id
]
1-25
Mode ◆ Global Config
◆ Interface Config
◆ VLAN Config
Format
no set igmp maxresponse [
vlan_id
]
Mode ◆ Global Config
◆ Interface Config
◆ VLAN Config
Default 0
Format
set igmp mcrtrexpiretime [
vlan_id
]
0-3600
Mode ◆ Global Config
◆ Interface Config
◆ VLAN Config
To Next Page
Loading...
