NetApp CN1610 - Show Isdp Interface

586 ISDP Commands
The following shows example CLI display output for the command.
(CN1610) #show isdp
Timer.......................................... 30
Hold Time...................................... 180
Version 2 Advertisements....................... Enabled
Neighbors table time since last change......... 0 days 00:00:00
Device ID...................................... 1114728
Device ID format capability.................... Serial Number, Host
Name
Device ID format............................... Serial Number
show isdp interface This command displays ISDP settings for the specified interface.
Device ID Format Indicates the Device ID format of the device.
◆ serialNumber indicates that the value is in the
form of an ASCII string containing the device
serial number.
◆ macAddress indicates that the value is in the
form of a Layer 2 MAC address.
◆ other indicates that the value is in the form of a
platform specific ASCII string containing info
that identifies the device. For example, ASCII
string contains serialNumber
appended/prepended with system name.
Term Definition
Format
show isdp interface {all | slot/port}
Mode Privileged EXEC
Term Definition
Interface The slot/port of the specified interface.
Mode ISDP mode enabled/disabled status for the
interface(s).