358 VLAN Commands
no vlan protocol
group name
This command removes the name from the group identified by groupid.
vlan protocol group
add protocol
This command adds the
protocol to the protocol-based VLAN identified by
groupid. A group may have more than one protocol associated with it. Each
interface and protocol combination can only be associated with one group. If
adding a protocol to a group causes any conflicts with interfaces currently
associated with the group, this command fails and the protocol is not added to the
group. The possible values for
protocol are The possible values for protocol-
list includes the keywords
ip, arp, and ipx and hexadecimal or decimal
values ranging from 0x0600 (1536) to 0xFFFF (65535). The protocol list can
accept up to 16 protocols separated by a comma.
no vlan protocol
group add protocol
This command removes the protocols specified in the
protocol-list from
this protocol-based VLAN group that is identified by this
groupid.
protocol group This command attaches a
vlanid to the protocol-based VLAN identified by
groupid. A group may only be associated with one VLAN at a time, however
the VLAN association can be changed.
Format
no vlan protocol group name
groupid
Mode Global Config
Default none
Format
vlan protocol group add protocol
groupid ethertype
protocol-list
Mode Global Config
Format
no vlan protocol group add protocol
groupid ethertype
protocol-list
Mode Global Config
Default none
Format
protocol group
groupid vlanid
To Next Page
Loading...
