NetApp CN1610 - No Set Igmp Querier Timer Expiry; Set Igmp Querier Version; No Set Igmp Querier Version; Set Igmp Querier Election Participate

Chapter 5: Switching Commands 521
no set igmp querier
timer expiry
Use this command to set the IGMP Querier timer expiration period to its default
value.
set igmp querier
version
Use this command to set the IGMP version of the query that the snooping switch
is going to send periodically.
no set igmp querier
version
Use this command to set the IGMP Querier version to its default value.
set igmp querier
election participate
Use this command to enable the Snooping Querier to participate in the Querier
Election process when it discovers the presence of another Querier in the VLAN.
When this mode is enabled, if the Snooping Querier finds that the other Querier’s
source address is better (less) than the Snooping Querier’s address, it stops
sending periodic queries. If the Snooping Querier wins the election, then it will
continue sending periodic queries.
Format
no set igmp querier timer expiry
Mode Global Config
Default 1
Format
set igmp querier version 1-2
Mode Global Config
Format
no set igmp querier version
Mode Global Config
Default disabled
Format
set igmp querier election participate
Mode VLAN Config