Chapter 5: Switching Commands 453
no lacp partner port
priority
Use this command to configure the default LACP partner port priority.
lacp partner
system-id
Use this command to configure the 6-octet MAC Address value representing the
administrative value of the Aggregation Port’s protocol Partner’s System ID. This
command can be used to configure a single interface or a range of interfaces. The
valid range of
system-id is 00:00:00:00:00:00 - FF:FF:FF:FF:FF.
This command is applicable only to physical interfaces.
no lacp partner
system-id
Use this command to configure the default value representing the administrative
value of the Aggregation Port’s protocol Partner’s System ID.
lacp partner system
priority
Use this command to configure the administrative value of the priority associated
with the Partner’s System ID. This command can be used to configure a single
interface or a range of interfaces. The valid range for
priority is 0 to 65535.
Format
no lacp partner port priority
Mode Interface Config
Default 00:00:00:00:00:00
Format
lacp partner system-id
system-id
Mode Interface Config
Format
no lacp partner system-id
Mode Interface Config
Default 0x0
Format
lacp partner system priority
0-65535
Mode Interface Config
To Next Page
Loading...
