Chapter 7: Quality of Service Commands 649
mac access-list
extended rename
This command changes the name of a MAC Access Control List (ACL). The
name parameter is the name of an existing MAC ACL. The newname parameter
is a case-sensitive alphanumeric string from 1 to 31 characters uniquely
identifying the MAC access list.
This command fails if a MAC ACL by the name
newname already exists.
{deny | permit}
(MAC ACL)
This command creates a new rule for the current MAC access list. Each rule is
appended to the list of configured rules for the list. A rule may either deny or
permit traffic according to the specified classification fields. At a minimum, the
source and destination MAC value must be specified, each of which may be
substituted using the keyword any to indicate a match on any value in that field.
The remaining command parameters are all optional, but the most frequently
used parameters appear in the same relative order as shown in the command
format.
The no form of this command is not supported, since the rules within a MAC
ACL cannot be deleted individually. Rather, the entire MAC ACL must be
deleted and respecified.
An implicit deny all MAC rule always terminates the access list.
The Ethertype may be specified as either a keyword or a four-digit hexadecimal
value from 0x0600-0xFFFF. The currently supported
ethertypekey values are:
appletalk, arp, ibmsna, ipv4, ipv6, ipx, mplsmcast, mplsucast, netbios, novell,
pppoe, rarp. Each of these translates into its equivalent Ethertype value(s).
Format
mac access-list extended rename
name newname
Mode Global Config
Format
{deny|permit} {
srcmac
| any} {
dstmac
| any}
[
ethertypekey
|
0x0600-0xFFFF
] [vlan {eq
0-4095
}]
[cos
0-7
] [[log] [time-range
time-range-name
] [assign-
queue
queue-id
]] [{mirror | redirect} slot/port][rate-
limit
rate burst-size
]
Mode Mac-Access-List Config
To Next Page
Loading...
