Chapter 5: Switching Commands 435
storm-control
broadcast rate
Use this command to configure the broadcast storm recovery threshold for all
interfaces (Global Config mode) or one or more interfaces (Interface Config
mode) in packets per second. If the mode is enabled, broadcast storm recovery is
active, and if the rate of L2 broadcast traffic ingressing on an interface increases
beyond the configured threshold, the traffic is dropped. Therefore, the rate of
broadcast traffic is limited to the configured threshold.
no storm-control
broadcast rate
This command sets the broadcast storm recovery threshold to the default value
for all interfaces (Global Config mode) or one or more interfaces (Interface
Config mode) and disables broadcast storm recovery.
storm-control
multicast
This command enables multicast storm recovery mode for all interfaces (Global
Config mode) or one or more interfaces (Interface Config mode). If the mode is
enabled, multicast storm recovery is active, and if the rate of L2 multicast traffic
ingressing on an interface increases beyond the configured threshold, the traffic
will be dropped. Therefore, the rate of multicast traffic will be limited to the
configured threshold.
Format
no storm-control broadcast level
Mode â—† Global Config
â—† Interface Config
Default 0
Format
storm-control broadcast rate
0-14880000
Mode â—† Global Config
â—† Interface Config
Format
no storm-control broadcast rate
Mode â—† Global Config
â—† Interface Config
Default disabled
To Next Page
Loading...
Need help?
General
