Chapter 3: Management Commands 35
The following shows example CLI display output for the network port.
(CN1610) #show network
Interface Status............................... Down
IP Address..................................... 0.0.0.0
Subnet Mask.................................... 0.0.0.0
Default Gateway................................ 0.0.0.0
IPv6 Administrative Mode....................... Enabled
Burned In MAC Address.......................... 00:A0:98:EA:2E:7A
Locally Administered MAC address............... 00:00:00:00:00:00
MAC Address Type............................... Burned In
Configured IPv4 Protocol....................... None
Configured IPv6 Protocol....................... None
IPv6 AutoConfig Mode........................... Disabled
Management VLAN ID............................. 1
show serviceport This command displays service port configuration information.
DHCPv6 Client
DUID
The DHCPv6 client’s unique client identifier. This
row is displayed only when the configured IPv6
protocol is dhcp.
IPv6 Autoconfig
Mode
Whether IPv6 Stateless address autoconfiguration is
enabled or disabled.
Management VLAN The VLAN used to establish an IP connection to the
switch from a workstation that is connected to a port
in the same VLAN.
Term Definition
Format
show serviceport
Mode ◆ Privileged EXEC
◆ User EXEC
To Next Page
Loading...
