36 Network Interface Commands
The following shows example CLI display output for the service port.
(CN1610) #show serviceport
Interface Status............................... Up
IP Address..................................... 10.27.21.176
Subnet Mask.................................... 255.255.252.0
Default Gateway................................ 10.27.20.1
IPv6 Administrative Mode....................... Enabled
Term Definition
Interface Status The network interface status. It is always considered
to be up.
IP Address The IP address of the interface. The factory default
value is 0.0.0.0.
Subnet Mask The IP subnet mask for this interface. The factory
default value is 0.0.0.0.
Default Gateway The default gateway for this IP interface. The
factory default value is 0.0.0.0.
IPv6 Administrative
Mode
Whether enabled or disabled. Default value is
enabled.
IPv6 Prefix is The IPv6 address and length. Default is Link Local
format.
Configured IPv4
Protocol
The IPv4 network protocol being used. The options
are bootp | dhcp | none.
Configured IPv6
Protocol
The IPv6 network protocol being used. The options
are dhcp | none.
DHCPv6 Client
DUID
The DHCPv6 client’s unique client identifier. This
row is displayed only when the configured IPv6
protocol is dhcp.
IPv6 Autoconfig
Mode
Whether IPv6 Stateless address autoconfiguration is
enabled or disabled.
Burned in MAC
Address
The burned in MAC address used for in-band
connectivity.
To Next Page
Loading...
