NetApp CN1610 - Time Zone Commands; Clock Set; Clock Summer-Time Date

Chapter 4: Utility Commands 231
Time Zone Commands
Use the Time Zone commands to configure system time and date, Time Zone and
Summer Time (that is, Daylight Saving Time). Summer time can be recurring or
non-recurring.
clock set This command sets the system time and date.
The following shows examples of the command.
(CN1610) (Config)# clock set 03:17:00
(CN1610) (Config)# clock set 11/01/2011
clock summer-time
date
Use the clock summer-time date command to set the summer-time offset to
Coordinated Universal Time (UTC). If the optional parameters are not specified,
they are read as either 0 or \0, as appropriate.
Format
clock set hh:mm:ss
clock set mm/dd/yyyy
Mode Global Config
Parameter Description
hh:mm:ss Enter the current system time in 24-hour format in
hours, minutes, and seconds. The range is hours: 0 to
23, minutes: 0 to 59, seconds: 0 to 59.
mm/dd/yyyy Enter the current system date the format month, day,
year. The range for month is 1 to 12. The range for
the day of the month is 1 to 31. The range for year is
2010 to 2079.
Format clock summer-time date {date month year hh:mm date month year
hh:mm}[offset offset] [zone acronym]
Mode Global Config