NetApp CN1610 - Show Spanning-Tree Uplinkfast

350 Spanning Tree Protocol Commands
Configuration Digest Key.......... ****
Configuration Format Selector..... 0
No MST instances to display.
show spanning-tree
uplinkfast
This command displays spanning tree information for uplinkfast.
The following shows example output from the command.
(CN1610) #show spanning-tree uplinkfast
Uplinkfast is enabled.
BPDU update rate : 150 packets/sec
Uplinkfast Statistics
---------------------
Uplinkfast transitions (all VLANs)................. 0
Proxy multicast addresses transmitted (all VLANs).. 0
Format
show spanning-tree uplinkfast
Mode ◆ Privileged EXEC
◆ User EXEC
Term Definition
Uplinkfast transitions
(all VLANs)
The number of uplinkfast transitions on all VLANs.
Proxy multicast
addresses transmitted
(all VLANs)
The number of proxy multicast addresses
transmitted on all VLANs.