NetApp CN1610 - Ip Dhcp Snooping Binding; No Ip Dhcp Snooping Binding; Ip Verify Binding; No Ip Verify Binding;Ip Dhcp Snooping Limit

Chapter 5: Switching Commands 489
ip dhcp snooping
binding
Use this command to configure static DHCP Snooping binding.
no ip dhcp
snooping binding
Use this command to remove the DHCP static entry from the DHCP Snooping
database.
ip verify binding Use this command to configure static IP source guard (IPSG) entries.
no ip verify binding Use this command to remove the IPSG static entry from the IPSG database.
ip dhcp snooping
limit
Use this command to control the rate at which the DHCP Snooping messages
come on an interface or range of interfaces. By default, rate limiting is disabled.
When enabled, the rate can range from 0 to 300 packets per second. The burst
level range is 1 to 15 seconds.
Mode Global Config
Format
ip dhcp snooping binding mac-address vlan vlan id ip
address
interface interface id
Mode Global Config
Format
no ip dhcp snooping binding mac-address
Mode Global Config
Format
ip verify binding mac-address vlan vlan id ip
address
interface interface id
Mode Global Config
Format
no ip verify binding mac-address vlan vlan id ip
address
interface interface id
Mode Global Config